Run ISA Server setup
To run ISA Server setup
- Open ISAautorun.exe from the root folder of the ISA Server CD or a shared folder on your network that contains the ISA Server files.
- After the setup program shows that it has completed determining the system configuration, on the Welcome page, click Next.
- If you accept the terms and conditions stated in the end-user license agreement, click I accept the terms in the license agreement, and then click Next.
- Type your customer details, and then click Next.
- Click Typical Installation, Full Installation, or Custom Installation.
-
Note There are four components that can be installed.
- ISA Server Services.
- The services that comprise ISA Server.
- ISA Server Management.
- The ISA Server Management user interface.
- Firewall Client Installation Share.
- A location from which client computers can install the Firewall Client software. This is typically installed on a computer other than the ISA Server computer, so it is not part of the Typical Installation option. The Firewall Client Share can be installed on computers running Windows Server 2003, Windows 2000 Server or Windows XP.
- Message Screener.
- A component that you configure to screen e-mail messages for keywords and attachments. This component must be installed on an SMTP server, which is typically not your ISA Server computer.
Typical Installation installs ISA Server Services and ISA Server Management. Full Installation installs all four components. Custom Installation enables you to select which components you will install.
- Click Next.
- Configure the Internal network. Follow these steps:
- Click Add.
- Click Configure Internal Network.
- Select Add address ranges based on the Windows Routing Table.
- Select one or more of the adapters that are connected to the Internal network. These addresses will be included in the Internal network that is defined by default for ISA Server.
- Clear the selection of Add the following private IP ranges, unless you want to add those ranges to your Internal network.
- Click OK. Read the Setup Message and click OK. Then click OK again to finish the Internal network configuration, and then click Next.
- Click Install.
- After the installation is complete, if you want to invoke ISA Server Management immediately, select the Invoke ISA Management check box, and then click Finish.
Notes
- To perform this procedure, you must be a member of the Administrators group.
- If you downloaded the ISA Server installation files from the Web, or if you copied the contents of the ISA Server CD, run the ISAautorun.exe file at a command prompt to begin the ISA Server installation. Then, click Install ISA Server.
- The MSDE component, required for many monitoring features, is not properly installed when you remotely install ISA Server, using Terminal Services in application server mode. Use Terminal Services in administration mode to properly install MSDE.
- If Internet Authentication Service (IAS) is running while ISA Server is being installed, you must restart IAS when installation completes. Otherwise, ISA Server will not accept VPN connections.
Related Topics:Installation requirements
